G0000176 – SYNC Software Programming v4.0 – Ford & Lincoln

Ford

General Service Bulletin (GSB): SYNC Software Programming v4.0 GSB Overview: Information on Programming the SYNC Accessory Protocol Interface Module (APIM) along with Recommended Computer Settings NOTE: This information is not intended to replace or supersede any warranty, parts and service policy, Work Shop Manual (WSM) procedures or technical training or wiring diagram information.   The … Read more

Rear Clunk, Squeak, or Rattle Type Noise Occurring Over Bumps And/Or When Turning – 2015 Ford Transit

2015 Transit – Rear Clunk, Squeak, or Rattle Type Noise Occurring Over Bumps And/Or When Turning – Built On Or Before 3/13/2015 Some 2015 Transit vehicles built on or before 3/13/2015 may exhibit a clunk, squeak, or rattle type noise from the rear of the vehicle over bumps and/or when turning.   The torque specification … Read more

Sirius Satellite Radio – Audio Cuts Out/No Signal – 2016-2017 Ford Escape

Ford

45806 – 2016-2017 Escape and 2017 Fusion – Sirius Satellite Radio – Audio Cuts Out/No Signal – Built On Or Before 8/21/2016 Some 2016-2017 Escape and 2017 Fusion vehicles equipped with Sirius satellite radio built on or before 8/21/2106 may exhibit an intermittent concern where the audio cuts out and the radio displays a No Signal message … Read more

Adaptive Cruise Control/Collision Warning Inoperative – DTC U3000 – 2015-2018 Ford & Lincoln

2018 Lincoln Continental

NHTSA ID Number: 10162086 Manufacturer Communication Number: SSM 48049   Summary Some 2015-2017 F-150/MustangeBay, 2015-2018 Edge/MKC, 2016-2018 MKX, 2013-2018 Explorer/Taurus/Flex/MKT, and 2017-2018 Fusion/MKZ/Continental vehicles built on or before 19-Oct-2017 may exhibit an inoperative adaptive cruise control, collision warning, and/or collision avoidance system with a Pre-Collision Assist Not Available, Collision Warning Not Available, and/or Adaptive Cruise Fault message … Read more

Open Hem Flanges At Bottom Of Door Panels – Ford & Lincoln

Multiple Vehicles – Open Hem Flanges At Bottom Of Door Panels Multiple vehicles may have an open style hem flange, which is a type of manufacturing process found near the bottom of door assemblies.   The design of the open hem flange incorporates a gap between the inner reinforcing panel and the outer portion of … Read more