Unable To Program And/Or No Electrical Power After Service Part Body Control Module (BCM) Installation – 2014 Ford Focus/C-Max

2014 – Focus/C-Max – Unable To Program And/Or No Electrical Power After Service Part Body Control Module (BCM) Installation – Missing Fuse 88

Some 2014-Focus/C-Max vehicles may exhibit a concern of not able to program and/or no electrical power after installation of a service part BCM.

 

Inspect the BCM for the presence of fuse F88.

If the fuse is missing, install the 25 Amp fuse and then re-evaluate the concern.

 


 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

  • Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
  • Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com

 

Leave A Comment

Your email address will not be published. Required fields are marked *

*