Difficult to Start, Runs Rough, Crank No Start, Lack of Power, Loss of RPM or Hesitation with (DTCs) P007B P0236 P06A7 – 2013-2014 Ford & Lincoln

“This site contains affiliate links for which OEMDTC may be compensated”
1.6L GTDI / 2.0L GTDI – SERVICE ENGINE SOON LIGHT – DTCS P007B/P0236/P06A7

 

FORD: 2013-2014 Fusion
LINCOLN: 2014 MKZ
FORD: 2013-2014 Escape

 

2013-2014 Escape vehicles built on or before 10/22/2013, 2013-2014 Fusion and 2014 MKZ vehicles built on or before 10/18/2013 and equipped with 1.6L or 2.0L Gasoline Turbocharged Direct Injection (GTDI) engines may exhibit difficult to start, runs rough at start up, crank no start, lack of power, loss of RPM or hesitation concerns with diagnostic trouble codes (DTCs) P007B or P0236 along with P06A7 stored in powertrain control module memory (PCM).

 

SERVICE PROCEDURE

  1. Using Integrated Diagnostic System (IDS) or Scan Tool, check for DTCs.
  1. Does the vehicle exhibit a driveability concern with DTC P007B or P0236 along with P06A7 stored?
    1. Yes – replace TCBP/CACT/MAPT sensor and fastener. Torque the fastener to 4.1 Nm +/- .7 Nm (36.3 lb-in +/- 6.2 lb-in) . Refer to Workshop Manual (WSM), and Wiring Diagram. (Figures 1 and 2)
      1. Other DTCs may also be present along with P007B, P0236 and P06A7, which share the VREF circuit.
      1. 1.6L GTDI engine TCBP/CACT (MAPT) sensor location. (Figure 1)
        1.6L GTDI engine TCBP/CACT (MAPT) sensor location
        Figure 1 – 14-0034
      1. 2.0L GTDI engine TCBP/CACT (MAPT) sensor location. (Figure 2)
        2.0L GTDI engine TCBP/CACT (MAPT) sensor location
        Figure 2 – 14-0034
    1. No – Perform normal Workshop Manual diagnostics.

 

PART NUMBER PART NAME
EL8Z-9F479-A Sensor Assembly
W716594-S450B Screw—Escape
W506974-S450B Screw—Fusion MKZ

 

1 thought on “Difficult to Start, Runs Rough, Crank No Start, Lack of Power, Loss of RPM or Hesitation with (DTCs) P007B P0236 P06A7 – 2013-2014 Ford & Lincoln”

  1. I have Ford Fiesta 1.5 tdci 2013 front damage I repair it engine management light was on I start car was ok but soon is I turn it of didn’t start again I was have to wait 20 second and then start again i take it to the 10 mechanics they put computer all of them they find same code which is ( P06A7 sensor reference voltage “b ” circuit range /performance. Current dtc ) each one of them they said change this sensor for example air filter sensor ! Map sensor ! Ac sensor ! Crank shift sensor and income sensor if I was listen to them probably all sensor cost me more then value of the car but I only change crank shift sensor and still was same but I come go under the car there was 2 plug one for ac other for fog light the one for fog light been close and there was water inside plug I cleaned and dry it and put it on fog light and other one was for ac I close the top until I get ac radiotar now every think working perfect and light go off

    Reply

Leave a Comment

Share to...