No Audio Output after Starting – 2013-2014 Ford & Lincoln

“This site contains affiliate links for which OEMDTC may be compensated”
TSB 14-0169 NO AUDIO OUTPUT AFTER STARTING

 

FORD: 2013-2014 Edge, Explorer, F-150
LINCOLN: 2013-2014 MKX

 

ISSUE:

Some 2013-2014 F-150, Explorer, Edge, and MKX vehicles may exhibit an intermittent concern of no audio output after starting the vehicle.

This may occur during cold ambient temperatures or when abnormally low battery voltage levels are present.

 

ACTION:

Reprogram the audio control module (ACM) to the latest calibration using IDS or Ford J2534 release 91.05 or higher. Make sure you are connected to the internet when entering module programming to guarantee you are receiving the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.

OPERATION DESCRIPTION TIME
140169A 2013-2014 Edge, MKX, Explorer And F-150: Reprogram The ACM And Clear Codes (Do Not Use With Any Other Labor Operations) 0.3 Hr.

 

WARRANTY STATUS

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

 

DEALER CODING

BASIC PART NO. CONDITION CODE
18C869 04

 

Loader Loading...
EAD Logo Taking too long?

Reload Reload document
| Open Open in new tab

Download [65.12 KB]

 

 


 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

  • Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
  • Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device No Audio Output after Starting - 2013-2014 Ford & Lincoln | small light No Audio Output after Starting - 2013-2014 Ford & Lincoln | small light No Audio Output after Starting - 2013-2014 Ford & Lincoln | small light No Audio Output after Starting - 2013-2014 Ford & Lincoln | small light using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com

 

Leave a Comment

Share to...