Timed 12 Volt Auxiliary Power Points Disable Immediately When Door Is Opened

“This site contains affiliate links for which OEMDTC may be compensated”

SSM 46497 – 2017 F-Super Duty – Timed 12 Volt Auxiliary Power Points Disable Immediately When Door Is Opened – Built On Or Before 22-Feb-2017

2017 F-Super Duty vehicles built on or before 22-Feb-2017 may have timed 12 volt auxiliary power points that disable when the ignition is turned off and a door is opened.

Power points are timed with the exception of the one located on the rear of the center console, if equipped.

Timed power points should remain on for 30 minutes when in accessory mode and 75 minutes when ignition is turned off.

To correct this condition, reprogram the body control module (BCM) to the latest calibration using IDS release 104.04 or higher.

Make sure you are connected to the internet when entering module programming to obtain the latest updates.

Calibration files may also be obtained at www.motorcraftservice.com.

For claiming, use causal part 15604 and applicable labor operations in section 10 of the service labor time standards (SLTS) manual.

APPLICABLE VEHICLES
2017 TRUCK: FE P558 SUPER DUTY – NA

https://static.nhtsa.gov/odi/tsbs/2017/SB-10100518-2532.pdf

Taking too long?

Reload document

Open in new tab

Download [6.19 KB]

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.