Radio Preset Issues After APIM Replacement – 2016 Ford Transit

“This site contains affiliate links for which OEMDTC may be compensated”

2016 TransitSYNC 3 – Radio Presets Inoperative After APIM Replacement

2016 Transit vehicles equipped with SYNC 3 may exhibit inoperative radio presets after accessory protocol interface module (APIM) replacement due to a software conflict between the replacement APIM and original audio control module (ACM).

 

Reprogram the ACM using Integrated Diagnostic System (IDS) release 105.03 or higher.

Make sure you are connected to the internet when entering module programming to obtain the latest updates.

Calibration files may also be obtained at www.motorcraftservice.com.

 


 

Module Reprogramming & Initialization

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

  • Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
  • Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device Radio Preset Issues After APIM Replacement - 2016 Ford Transit | small light Radio Preset Issues After APIM Replacement - 2016 Ford Transit | small light Radio Preset Issues After APIM Replacement - 2016 Ford Transit | small light Radio Preset Issues After APIM Replacement - 2016 Ford Transit | small light using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com

 

Leave a Comment

Share to...