| “This site contains affiliate links for which OEMDTC may be compensated” |
SSM 46393 – 2017 F-Super Duty – Dual Generator – Illuminated Charging Light And/Or Charging Warning Message Due To Single Generator Removal
Some 2017 F-Super Duty vehicles with dual generators may exhibit an illuminated charging light and/or charging warning message after an upfitter has removed one of the generators.
To correct this concern, use Integrated Diagnostic System (IDS) service tool version 104.02 or later to configure the generator setup.
These settings can be found under toolbox ⇒ module programming ⇒ programmable parameters ⇒ powertrain.
Details for this procedure can be found on the truck body builder advisory service (BBAS) website, found by clicking the link at the bottom of the webpage at https://www.fleet.ford.com.
Once at BBAS website, click on bulletins, and refer to published qualified vehicle modifier (QVM) bulletin for dual to signal generator conversion.
Changes to generator setup as a result of upfitter modifications are non-warrantable.
APPLICABLE VEHICLES
2017 TRUCK: FE P558 SUPER DUTY – NA
https://static.nhtsa.gov/odi/tsbs/2017/SB-10095843-2532.pdf
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
