| “This site contains affiliate links for which OEMDTC may be compensated” |
| HYBRID — ILLUMINATED MIL WITH DTCS P0030 AND/OR P0130 | |
| Publication Date: October 13, 2016 | |
This article supersedes TSB 10-17-11 to update the vehicle model years, Title, Issue Statement, Service Procedure and Part List.
ISSUE:
Some 2010-2012 Fusion Hybrid, Milan Hybrid and MKZ Hybrid vehicles may exhibit an illuminated malfunction indicator lamp (MIL) with diagnostic trouble codes (DTCs) P0030 and/or P0130.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Connect the Ford
Integrated Diagnostic System (IDS) service tool or equivalent scan tool and check for DTCs. Is DTC P0030 and/or P0130 present?
- Yes – proceed to Step 2.
- No – this procedure does not apply. Refer to Powertrain Control/Emission Diagnosis (PC/ED) manual for normal diagnostics.
- Replace the bank 1, sensor 1 heated oxygen sensor (H02S). Refer to Workshop Manual (WSM), Section 303-14.
- Reprogram the powertrain control module (PCM) to the latest calibration using the integrated diagnostic system (IDS) release 102.03 or higher. Make sure you are connected to the internet when entering module programing to obtain the latest updates. Calibration files may also be obtained at www.motorcraft.com.
8F9Z-9F472-B  | Heated Oxygen Sensor |
| OPERATION | DESCRIPTION | TIME |
| 160143A | 2010-2012 Fusion Hybrid, 2010-2011 Milan Hybrid, 2011-2012 MKZ Hybrid: Retrieve DTCs Replace HO2S And Reprogram The PCM (Do Not Use With Any Other Labor Operations) | 0.5 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| RECALEM | 04 |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
