| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 13-11-13 |
|
| Publication Date: November 5, 2013 | |
FORD : | 2013 F-650, F-750 |
ISSUE:
Some 2013 F-Super Duty 650/750 vehicles and equipped with a 6.8L engine may exhibit a delayed engagement for the SEIC-PTO mode operation after decelerating to a stop. Vehicles that are operated as roll-back wreckers or other similar uses of stationary PTO may exhibit slow re-entry into PTO mode after the vehicle is moved. Some vehicles exhibit more than 20 seconds of wait-time before stationary PTO is allowed by the engine controller. The calibration update contains improvement actions and enhancements to allow a more prompt re-entry into stationary PTO mode after the primary inputs are achieved (motionless vehicle, service brake engaged, in Park, and no brake or accelerator pedal inputs).
ACTION:
Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 87.03 and higher. Calibration files may also be obtained at www.motorcraft.com.
NOTE:
PLEASE ADVISE THE CUSTOMER THAT THIS VEHICLE IS EQUIPPED WITH AN ADAPTIVE TRANSMISSION SHIFT STRATEGY WHICH ALLOWS THE VEHICLE’S COMPUTER TO LEARN THE TRANSMISSION’S UNIQUE PARAMETERS AND IMPROVE SHIFT QUALITY. WHEN THE ADAPTIVE STRATEGY IS RESET, THE COMPUTER WILL BEGIN A RE-LEARNING PROCESS. THIS RE-LEARNING PROCESS MAY RESULT IN FIRMER THAN NORMAL UPSHIFTS AND DOWNSHIFTS FOR SEVERAL DAYS.
WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
| OPERATION | DESCRIPTION | TIME |
| 131113A | F-Super Duty 650/750 6.8L: Reprogram The PCM. Includes Time To Clear Codes (Do Not Use With Any Other Labor Operations) | 0.4 Hr. |
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| RECAL | 04 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
