Red Brake Warning Indicator – DTC C101A – 2013 Ford F-250 & F-350

TSB 13-6-26	6.2L ENGINE – RED BRAKE WARNING INDICATOR – DTC C101A:62 – BUILT ON OR BEFORE 2/21/2013
Publication Date: June 27, 2013

 

FORD:

2013 F-250, F-350

 

ISSUE:

Some 2013 F-Super Duty 250/350 vehicles equipped with 6.2L engine and built on or before 2/21/2013 may exhibit illuminated red brake warning indicator with diagnostic trouble code (DTC) C101A:62 – vacuum pressure sensor signal error in the anti-lock brake (ABS) module.

 

ACTION:

Reprogram the ABS module to the latest calibration using IDS release 85.03 and higher. Calibration files may also be obtained at www.motorcraft.com.

 

WARRANTY STATUS:

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

OPERATION	DESCRIPTION	TIME
130626A	2013 F-Super Duty 6.2L: Check DTCs And Reprogram The ABS Module (Do Not Use With Any Other Labor Operations)	0.2 Hr.

 

DEALER CODING

BASIC PART NO.	CONDITION CODE
2C219	04

 

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com