| “This site contains affiliate links for which OEMDTC may be compensated” |
2016 F150 – Equipped With SYNC 3 And Electronic Manual Temperature Control – Intermittent Display of Climate Control Features
Some 2016 F150 vehicles equipped with SYNC 3 and Electronic Manual Temperature Control (EMTC) may experience a condition in which the climate control features are displayed on the Front Display Interface Module (FDIM) randomly and usually after starting the vehicle.
The vehicle is not equipped with this feature and this is not a normal characteristic of an EMTC system.
To correct the condition, reprogram the Front Control Interface Module (FCIM) to the latest calibration using IDS release 103.03 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
