Electronic Park Brake (EPB) Malfunction (DTC) U3000 – 2015 Ford F-150

TSB 15-0102

ELECTRONIC PARKING BRAKE – PARKING BRAKE MALFUNCTION MESSAGE IN THE MESSAGE CENTER WITH DTC U3000 – BUILT ON OR BEFORE 2/21/2015

 

FORD:

2015 F-150

 

ISSUE:

Some 2015 F-150 vehicles equipped with an electronic park brake (EPB) and built on or before 2/21/2015 may exhibit a parking brake malfunction message displayed in the message center, a yellow park brake indicator illuminated and the red brake warning indicator flashing when activating the park brake with diagnostic trouble code (DTC) U3000:49 stored in the EPB module.

 

ACTION:

Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

1. Connect the Ford Integrated Diagnostic System (IDS) service tool or equivalent scan tool to the data link connector (DLC). Is DTC U3000:49 stored in the EPB module with any other DTCs?
   1. Yes – the module has more than one DTC code. Diagnose all other DTCs prior to performing this procedure. Refer to the Workshop Manual (WSM), Section 206-05 for normal diagnosis.
   2. No – proceed to step 2.
2. Is DTC U3000:49 stored in the EPB Module?
   1. Yes – replace the EPB module. Refer to Workshop Manual (WSM), Section 206-05.
   2. No – this article does not apply. Refer to WSM, Section 206-05 for normal diagnosis.

 

FL3Z-2C496-B

Electronic Park Brake Module

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com