| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 15-0097 | 2.3L ECOBOOST – MANUAL TRANSMISSION – ILLUMINATED MIL – DTCS P0300 AND/OR P0316 – BUILT ON OR AFTER 12/20/2014 AND THROUGH 5/21/2015 |
ISSUE:
Some 2015 Mustang
vehicles equipped with a 2.3L EcoBoost engine and manual transmission built on or after 12/20/2014 and through 5/21/2015 may exhibit an illuminated malfunction indicator lamp (MIL) with DTCs P0300 and/or P0316 with no drivability concerns.
ACTION:
Reprogram the powertrain control module (PCM) to the latest calibration using IDS or Ford J2534 release 95.05 and higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
