Multimedia Display Missing the Compass and Turn-by-Turn Display – 2014 Ford Taurus & Lincoln MKS

TSB 14-0109	RIGHT HAND MULTIMEDIA DISPLAY AREA MISSING THE COMPASS AND TURN BY TURN DISPLAY – BUILT ON OR BEFORE 1/25/2014
Publication Date: May 22, 2014

 

FORD:	2014 Taurus
LINCOLN:	2014 MKS

 

ISSUE:

Some 2014 Taurus or MKS vehicles built on or before 1/25/2014 may exhibit an issue where the instrument panel cluster (IPC) right hand multimedia display area is missing the compass and turn-by-turn display.

 

ACTION:

Follow the Service Procedure steps to correct the condition.

 

SERVICE PROCEDURE

1. Using Integrated Diagnostic System (IDS), Select ToolBox, Module Programming, As-built, IPC.
2. Use the automatic function for programming the module with the as-built data pulled from PTS.

 

OPERATION	DESCRIPTION	TIME
140109A	2014 Taurus, MKS: Program The IPC Module Using As-Built Data (Do Not Use With Any Other Labor Operations)	0.2 Hr.

 

WARRANTY STATUS

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

 

DEALER CODING

BASIC PART NO.	CONDITION CODE
10849	04

 

 

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com