| “This site contains affiliate links for which OEMDTC may be compensated” |
| 5.0L ENGINE AND AUTOMATIC TRANSMISSION – DIAGNOSTIC TROUBLE CODE (DTC) P219A AND/OR P219B |
| FORD: | 2012-2014 Mustang |
2012-2014 Mustang vehicles equipped with a 5.0L engine and automatic transmission may exhibit a malfunction indicator lamp (MIL) illuminated with DTC P219A and/or P219B stored in powertrain control module (PCM) memory.
SERVICE PROCEDURE
- Connect the Ford Integrated Diagnostic System (IDS) service tool or equivalent Scan Tool, check for PCM DTCs.
- Are DTC P219A and/or P219B the only codes present in PCM memory?
- Yes – proceed to Step 3.
- No – this article does not apply. Refer to Powertrain Control/Emission Diagnosis (PC/ED) manual for normal diagnostics.
- Reprogram the PCM to the latest calibration using IDS or Ford J2534 release 90.05 or higher. Calibration files may also be obtained at www.motorcraft.com.
NOTE: ADVISE THE CUSTOMER THAT THIS VEHICLE IS EQUIPPED WITH AN ADAPTIVE TRANSMISSION SHIFT STRATEGY WHICH ALLOWS THE VEHICLE’S COMPUTER TO LEARN THE TRANSMISSION’S UNIQUE PARAMETERS AND IMPROVE SHIFT QUALITY. WHEN THE ADAPTIVE STRATEGY IS RESET, THE COMPUTER WILL BEGIN A RE-LEARNING PROCESS. THIS RE-LEARNING PROCESS MAY RESULT IN FIRMER THAN NORMAL UPSHIFTS AND DOWNSHIFTS FOR SEVERAL DAYS.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
