| “This site contains affiliate links for which OEMDTC may be compensated” |
2015 Lincoln
MKC – Dead Battery Due To Welcome Lighting Cycling On And Off – Built On Or Before 1/31/2015
2015 Lincoln MKC vehicles built on or before 1/31/2015 can exhibit a discharged battery due to welcome lighting cycling on and off when the keyfob is left with in detection range of the vehicle.
If the vehicle is built on or before 8/20/2014 reprogram the RTM and the BCM to the latest level using IDS or Ford J2534 version 95.01or higher.
If the vehicle was built on 8/21/2014 and through 1/31/2015, reprogram only the BCM to the latest level using version 95.01 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
