| “This site contains affiliate links for which OEMDTC may be compensated” |
2015 F-150 Vehicles – Factory Mode Enable Feature Using IDS
2015 F-150 vehicles may be delivered with Factory Mode displayed on the Instrument Cluster.
To correct the concern, release 94.01 and later will provide the ability reconfigure a unit into Transport Mode from Factory Mode.
This is done by following the steps using IDS or Ford J2534.
Open a new IDS or J2534 session and go to Module Programming > Programmable Parameters > Personality > Transport Mode > Enable/Disable. Select Enable.
Then select Disable for any Programmable Parameters that have a question mark. Click the tick mark to configure.
Close the IDS session once it has completed.
The Transport Mode is disabled after 201 km (125 Miles).
Additionally, for units removed from Transport mode before customer delivery, the IDS or Ford J2534 will allow you to configure the unit back into Transport Mode to reduce battery drain while in Dealer stock.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
My 2013 F150 limited keep goes into either transport mode or factory mode every day. Every morning I crank up my truck its says battery saver and it takes me at least 20 minutes before I get radio/ac function and control. Anybody knows what cause this.