| “This site contains affiliate links for which OEMDTC may be compensated” |
2017 F-150 Vehicles Equipped with an 8” Instrument Panel Cluster (IPC) Display – Software Installation Failures.
NO FURTHER IPC MODULE PROGRAMMING SHOULD BE ATTEMPTED AT THIS TIME.
Contacts to the Technical Assistance Center and the Special Service Support Center indicate software installed using IDS level 105.03 or later risk blanking the IPC module.
Engineering is developing new software for a future IDS release.
Continue to monitor OASIS for updates.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
