| “This site contains affiliate links for which OEMDTC may be compensated” |
| ENGINE OIL SERVICE REQUIRED MESSAGE IN THE INSTRUMENT PANEL CLUSTER (IPC) – BUILT ON OR BEFORE 4/5/2016 | |
| Publication Date: June 14, 2016 | |
FORD : | 2013-2016 Fiesta |
ISSUE:
Some 2013-2016 Fiesta vehicles built on or before 4/5/2016 may exhibit the Engine Oil Service Required message in the IPC that cannot be cleared following the normal service procedure.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Reprogram the powertrain control module (PCM) and the IPC to the latest calibration using IDS release 100.03 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.
- If the transmission control module (TCM) calibration required an update when the PCM calibration was updated, perform the clutch adaptive learning procedure. Using IDS service tool or equivalent, select Powertrain, Transmission, Transmission Adaptive Learning and perform the Clutch Adaptive Learning.
NOTE: ADVISE THE CUSTOMER THAT THIS VEHICLE IS EQUIPPED WITH AN ADAPTIVE TRANSMISSION SHIFT STRATEGY WHICH ALLOWS THE VEHICLE’S COMPUTER TO LEARN THE TRANSMISSION’S UNIQUE PARAMETERS AND IMPROVE SHIFT QUALITY. WHEN THE ADAPTIVE STRATEGY IS RESET, THE COMPUTER WILL BEGIN A RE-LEARNING PROCESS. THIS RE-LEARNING PROCESS MAY RESULT IN FIRMER THAN NORMAL UPSHIFTS AND DOWNSHIFTS FOR SEVERAL DAYS.
| OPERATION | DESCRIPTION | TIME |
| 160089A | 2013-2016 Fiesta With Manual Transmission: Reprogram The PCM and IPC (Do Not Use With Any Other Labor Operations) | 0.4 Hr. |
| 160089A | 2013-2016 Fiesta With Automatic Transmission (DPS6): Reprogram The PCM/IPC/TCM And Perform The Clutch Adaptive Learning Procedure (Do Not Use With Any Other Labor Operations) | 0.6 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 12A650 | 04 |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
