| “This site contains affiliate links for which OEMDTC may be compensated” |
2017 Fusion/MKZ – Illuminated Air Bag Lamp – Built On Or Before 18-Aug-2016
Some 2017 Fusion/MKZ vehicles built on or before 18-Aug-2016 may exhibit an airbag lamp.
Connect the IDS and check the RCM for DTCs. If DTC U3000, U2100, U2101, U2300, U0455, U0452, B0080, B141B, B141C, B0054, B140C, B140D, B0057, B140E, and/or B140F are stored in the RCM, reprogram the RCM to the latest level using IDS release 102.03 or higher.
After reprograming, perform an as-built configuration of the RCM. Select NO when asked if you were sent here by an article.
Make sure you are connected to the internet when entering module programming to obtainthe latest updates.
Calibration files may also be obtained at www.motorcraftservice.com
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford
, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
