2016 F150, Mustang And Explorer – No Audio After Starting The Engine – Screen Displays Loading Or Audio Off Message – Built On Or Before 4/15/2016
Some 2016 F150, Mustang and Explorer vehicles equipped with a 3.5L GTDI, 2.3L GTDI or 2.7L GTDI engine built on or before 4/15/2016, and equipped with Active Noise Cancellation (ANC) or Engine Sound Enhancement (ESE), may exhibit no audio and/or display an Audio Off or Loading message after starting the engine.
Reprogram the Audio Control Module (ACM) to the latest calibration using IDS release 101.03 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
