| “This site contains affiliate links for which OEMDTC may be compensated” |
2016 Fiesta With Electronic Automatic Temperature Control (EATC) – Heat Only In High Auto – Built On 9/15/2015 And Through 12/15/2015
Some 2016 Fiesta vehicles built on 9/15/2015 and through 12/15/2015 equipped with EATC needs to be set on high auto for the heat to operate.
Reprogram the heating ventilation and air conditioning (HVAC) module to latest calibration using the Integrated Diagnostic System (IDS) release 99.02 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford
, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
