Factory Trailer Brake Controller Installation

“This site contains affiliate links for which OEMDTC may be compensated”

2011-2014 F-150 – Trailer Brake Controller Installation

If a Dealership is installing a factory Trailer Brake Controller (TBC) on a 2011-2014 F-150, instructions are available in the Workshop Manual, Section 206-10 or on the Ford Accessories Website.

Once TBC is installed, use IDS 70.02 or later to configure the Instrument Cluster (IC) for TBC.

Enable the TBC/IC Message Center Gain Display and then enable the Trailer Sway parameter under the Personality section of Programmable Parameters.

The Factory TBC connector C2142 is located under the steering column near the Data Link Connector or plugged into the backside of the IP coin holder.

The installation of a TBC on a vehicle that was not originally equipped is not warrantable.

To determine if a vehicle was originally equipped with TBC, click the additional vehicle info link in OASIS and search for code FDDAD – INTEGRATED BRAKE CONTROL.

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.