| “This site contains affiliate links for which OEMDTC may be compensated” |
2015-2016 Mustang
Convertible With Audio Digital Signal Processing (DSP) Module- No Audio After An Engine Crank/Start Event – Built On Or Before 11/15/2015
Some 2015 and 2016 Mustang convertible vehicles equipped with a DSP module and built on or before 11/17/2015 may exhibit a no audio condtion after an engine crank/start event.
These are units containing the 9 speaker or 12 speaker Shaker audio systems.
Reprogram the DSP module to the latest calibration using IDS release 98.03 or higher.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
