| “This site contains affiliate links for which OEMDTC may be compensated” |
2014-2016 Transit Connect Titanium – Intermittent Cornering Lamps Operation – Built On Or Before 9/8/2015
2014-2016 Transit Connect Titanium vehicles built on or before 9/8/2015 can exhibit a concern in which the cornering lamps stop illuminating intermittently when using the turn signal switch.
Cornering lamp illumination based on steering wheel angle input continues to work properly.
Cycling the ignition Off and then On resumes cornering lamp illumination from the turn signal input, however, the concern may occur again.
Reprogram the Headlamp Control Module (HCM) to the latest calibration using Diagnostic System release 97.04 and higher.
Calibration files may also be obtained at www.motorcraftservice.com
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford
, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
