DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI) – 2015 Ford F-150

“This site contains affiliate links for which OEMDTC may be compensated”

2015 F-150 – 5.0L DOHC – DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI).

Some 2015 F-150 vehicles equipped with a 5.0L engine and built on or before 8/22/2015 may exhibit an illuminated MIL with diagnostic trouble codes (DTC) P0315 after PCM reprogramming, replacement or PMI procedure.

 

To erase this DTC, perform the Misfire Monitor Neutral Profile Correction procedure using the Ford Integrated Diagnostic System (IDS) scan tool or equivalent Scan Tool.

 

Do not replace PCM.

If build date is after 8/22/15 and vehicle exhibits DTC P0315 the PCM may have been reprogrammed with unauthorized aftermarket calibration.

 


 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

  • Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
  • Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI) - 2015 Ford F-150 | small light DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI) - 2015 Ford F-150 | small light DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI) - 2015 Ford F-150 | small light DTC P0315 After Powertrain Control Module (PCM) Reprogramming, Replacement or Programmable Module Installation (PMI) - 2015 Ford F-150 | small light using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com

 

Leave a Comment

Share to...