| “This site contains affiliate links for which OEMDTC may be compensated” |
| ANALOG SPEEDOMETER NEEDLE STICKING AND/OR INCORRECT SPEED INDICATION – BUILT ON OR BEFORE 8/31/2015 |
FORD : | 2015 F-150 |
ISSUE:
Some 2015 F-150 vehicles built on or before 8/31/2015 may exhibit an analog speedometer needle that sticks and/or indicates a vehicle speed while the vehicle is in park.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Does the digital speedometer within the information display read correctly?
- Yes – proceed to Step 2.
- No – this article does not apply. Refer to the Workshop Manual (WSM), Section 413-01 for normal diagnostics.
- Replace the instrument panel cluster (IPC). Refer to the WSM, Section 413-01.
| 10849 | Instrument Panel Cluster – See Parts Catalog For Specific Application |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
