| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 15-0132 | MANUAL TRANSMISSION – ENGINE OIL MINDER – OIL CHANGE NOW INDICATOR MESSAGE INOPERATIVE – BUILT ON OR BEFORE 6/1/2015 |
FORD : | 2014-2015 Fiesta |
ISSUE:
Some 2014-2015 Fiesta vehicles equipped with a manual transmission and built on or before 6/1/2015 may exhibit an oil change now indicator message that is inoperative.
ACTION:
Reprogram the instrument panel cluster (IPC) and the powertrain control module (PCM) to the latest calibration using IDS or Ford J2534 version 96.04 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
| OPERATION | DESCRIPTION | TIME |
|---|---|---|
| 150132A | 2014-2015 Fiesta With Manual Transmission: Reprogram The IPC And PCM (Do Not Use With Any Other Labor Operations) | 0.4 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 10849 | 04 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
