| “This site contains affiliate links for which OEMDTC may be compensated” |
2016 Expedition – Backup Camera Backup Lines Missing In Display – Built On Or After 07/27/2015 Through 08/03/2015
Some 2016 Expedition vehicle Built On Or After 07/27/2015 Through 08/03/2015 can exhibit the rear parking aid video camera display not displaying the fixed guidelines.
If encountered the camera will need to be configured through the BCM (Body Control Module) using IDS (Integrated Diagnostic System).
Perform PMI (programmable module installation) procedure for the BCM located in section 419-10 of the workshop manual.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford
, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
