Armrest does not Stow Flush with Rear Seat Back – 2015 Ford F-150 – Ford & Lincoln

“This site contains affiliate links for which OEMDTC may be compensated”

SUPERCREW – REAR SEAT CENTER ARMREST DOES NOT STOW FLUSH WITH REAR SEAT BACK – BUILT ON OR BEFORE 4/27/2015

FORD:

2015 F-150

ISSUE:

Some 2015 F-150 SuperCrew vehicles built on or before 4/27/2015 and equipped with a rear seat center armrest may exhibit a concern where the armrest does not stow flush with the rear seat back.

ACTION:

Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

Inspect the rear seat center armrest to be sure the stowage pocket is clear of obstructions and verify the concern.

Remove the left hand (LH) rear seat backrest cover and foam pad. Refer to the Workshop Manual (WSM), Section 501-10.

Using a razor blade or similar tool cut two 10 mm x 10 mm x 100 mm (13/32″ x 13/32″ x 4″) trenches into both upper corners of the armrest pocket in the rear seat backrest foam pad. (Figure 1)

Figure 1 – 15-0080
1. Do not cut into the surrounding foam bead.

Replace the LH rear seat backrest cover with the latest level service part, reusing the modified foam pad. Refer to the WSM, Section 501-10.

PART NUMBER	PART NAME
FL3Z-1666601-ED	Lariat Gray Cover
FL3Z-1666601-EE	Lariat Ebony Cover
FL3Z-1666601-EF	Lariat Camel Cover
FL3Z-1666601-FD	Platinum Ebony Cover
FL3Z-1666601-FC	Platinum Brunello Co
FL3Z-1666601-GB	King Ranch Cover
CU5Z-96610A16-BY	Camel Locking Guide
CU5Z-96610A16-BAA	Camel Non-Locking
CU5Z-96610A16-BH	Brunello Lock Guide
CU5Z-96610A16-BX	Gray Locking Guide
CU5Z-96610A16-BP	Brunello Non-Locking
CU5Z-96610A16-BZ	Gray Non-Locking
CU5Z-96610A16-BK	Ebony Locking Guide
CU5Z-96610A16-BR	Ebony Non-Locking

OPERATION	DESCRIPTION	TIME
150080A	2015 F-150 SuperCrew: Replace The Left Hand Rear Seat Backrest Cover Includes Time To Trim Foam And Remove And Install Seat (Do Not Use With Any Other labor Operations)	2.1 Hrs.

WARRANTY STATUS

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.