Illuminated Wrench Lamp or Red Triangle lamp with Diagnostic Trouble Code (DTC) P061A – 2014 Ford Fusion & Lincoln MKZ

TSB 14-0018

WRENCH LAMP WITH DTC P061A – REDUCTION IN VEHICLE POWER

 

FORD:	2014 Fusion
LINCOLN:	2014 MKZ

 

ISSUE:

Some 2014 Fusion/MKZ Hybrid and Energi vehicles may exhibit an illuminated wrench lamp or red triangle lamp or both with diagnostic trouble code (DTC) P061A present in the powertrain control module (PCM) and/or Secondary On Board Diagnostic Module C (SOBDMC).

 

ACTION:

Reprogram the PCM to the latest calibration using IDS or Ford J2534 release 88.01 and higher.

Calibration files may also be obtained at www.motorcraft.com.

OPERATION	DESCRIPTION	TIME
140018A	2014 Fusion, MKZ Hybrid And Energi: Reprogram The Appropriate Modules As Required By The Software Update Includes Time To Clear Codes After Repair (Do Not Use With Any Other Labor Operations)	0.5 Hr.

 

WARRANTY STATUS

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

 

DEALER CODING

BASIC PART NO.	CONDITION CODE
RECALEM	04

 

 

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com