| “This site contains affiliate links for which OEMDTC may be compensated” |
| INCONSISTENT CLIMATE CONTROL FUNCTION WHEN USING REMOTE START – BUILT ON OR BEFORE 1/31/2013 |
| FORD: | 2011-2013 Edge, Explorer |
| LINCOLN: | 2011-2013 MKX |
2011-2013 Edge, MKX and Explorer vehicles equipped with factory installed or Ford accessory remote start and built on or before 1/31/2013 may exhibit inconsistent operation of the climate control functions after a remote start event.
ACTION:
Reprogram the heating ventilation air conditioning (HVAC) module to the latest calibration using IDS or Ford J2534 release 89.02 or higher.
Calibration files may also be obtained at www.motorcraft.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
