| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 14-0039 | WRENCH LIGHT ILLUMINATED – DIAGNOSTIC TROUBLE CODE (DTC) P166A – MEMORY SEAT RECALL FUNCTION INOPERATIVE DURING PASSIVE ENTRY |
| FORD: | 2013 Fusion |
| LINCOLN: | 2013 MKZ |
This article supersedes TSB 13-6-16 to update the IDS version.
ISSUE:
Some 2013 Fusion and MKZ vehicles may exhibit an illuminated wrench light with DTC P166A stored in the powertrain control module (PCM), or the memory seat recall function may be inoperative during passive entry.
ACTION:
Reprogram the Body Control Module (BCM) to the latest calibration using IDS or Ford J2534 release 89.02 and higher.
Calibration files may also be obtained at www.motorcraft.com.
| OPERATION | DESCRIPTION | TIME |
|---|---|---|
| 140039A | 2013 Fusion And MKZ: Check DTCs And Reprogram The BCM Includes Time To Clear Codes After Repair (Do Not Use With Any Other Labor Operations) | 0.3 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 15604 | 42 |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
