| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 14-0159 | 4.2 INCH INFORMATION DISPLAY – UP AND DOWN ARROWS INOPERATIVE ON THE STEERING WHEEL AND OR THE FCDIM – BUILT ON OR BEFORE 11/18/2013 |
FORD : | 2013 F-150 |
ISSUE:
Some 2013 F-150 vehicles built on or before 11/18/2013 and equipped with a 4.2 inch information display may exhibit a concern of the up and down arrows intermittently inoperative on the steering wheel and or the front control display interface module (FCDIM).
ACTION:
Reprogram the FCDIM to the latest calibration using IDS or Ford J2534 release 91.04 and higher.
Please ensure that you are connected to the internet when entering module programming to guarantee that you will receive the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
| OPERATION | DESCRIPTION | TIME |
|---|---|---|
| 140159A | 2013 F-150: Reprogram The FCDIM And Clear Codes (Do Not Use With Any Other Labor Operations) | 0.3 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 10D885 | 42 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
