| “This site contains affiliate links for which OEMDTC may be compensated” |
2013-2014 Focus ST – Headlamp Fault Message With Normal Exterior Lighting Function
2013-2014 Focus ST vehicles equipped with High-Intensity Discharge (HID) headlamps can exhibit an intermittent headlamp fault message when all exterior lamps are operating properly.
To correct this condition, reprogram the Headlamp Control Module (HCM) to the latest calibration using release 94.05 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files can also be obtained at www.motorcraftservice.com
Ensure all scan tool cables are securely connected while programming, and the scan tool and vehicle battery are connected to chargers.
If module programming is interrupted the HCM may become inoperative.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
