โThis site contains affiliate links for which OEMDTC may be compensatedโ |
TSB 14-0190 | APPROACH DETECTION/WELCOME LIGHTING INOPERATIVE – BUILT ON OR BEFORE 7/19/2014 |
Publication Date: October 8, 2014 |
LINCOLN![]() | 2015 MKC |
This article supersedes TSBs 14-0152 and 14-0178 to consolidate previously released information.
ISSUE:
Some 2015 Lincoln MKC vehicles built on or before 7/19/2014 may exhibit an inoperative Approach Detection/Welcome Lighting feature with no diagnostic trouble codes (DTCs). When this occurs the Approach Detection system will remain inoperative until the body control module (BCM) is reset.
ACTION:
Reprogram the BCM to the latest calibration using IDS release 92.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com
OPERATION | DESCRIPTION | TIME |
140190A | 2015 MKC: Retrieve DTCs, Reprogram The BCM And Clear Codes (Do Not Use With Any Other Labor Operations) | 0.3 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
BASIC PART NO. | CONDITION CODE |
15604 | 04 |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln
and Mercury
vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln
and Mercury
vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data