| “This site contains affiliate links for which OEMDTC may be compensated” |
|
| FORD: | 2001 ESCAPE |
Some vehicles may exhibit a red charge lamp illumination in cold ambient temperatures below -6°C (20°F).
This may be caused by the calibration of the Powertrain Control Module (PCM).
ACTION:
Verify red charge lamp illumination.
If normal diagnostics cannot resolve condition, reprogram the Powertrain Control Module (PCM) with latest calibration.
Refer to the following PCM Calibration Information Chart for details.
| PCM CALIBRATION INFORMATION | ||||||
|---|---|---|---|---|---|---|
| Application | Old Part Number (-12A650-) | Tear Tag | New Part Number (-12A650-) | Old Calibration | New Calibration | NGS/WDS Qualifier |
| 2.0L Manual Trans LEV (US) | YL8F-GD | GSW4 | YL8Z-GE | 0M12A20510 | 0M12A20511 | WDS B11_11 release |
| 2.0L Manual Trans CAA (Clean Air Act) | YL8F-PD | HQE4 | YL8Z-PE | 0M12B20510 | 0M12B20511 | WDS B11_11 release |
| 2.0L Automatic (CD4E) Clean Air Act (CAA) | YL8F-TE | KXS5 | YL8Z-TF | 0M11A20511 | 0M11A20512 | WDS B11_11 release |
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
