| “This site contains affiliate links for which OEMDTC may be compensated” |
2017 Escape – IPC And/Or ABS Module – Module Reprogramming And/Or Traction Control (TC) Switch Inoperative – Built On Or Before 18-Jul-2016
2017 Escape vehicles built on or before 18-Jul-2016 that require instrument panel cluster (IPC) and/or anti-lock brake system (ABS) module replacement and/or reprogramming requires that both modules are programmed by the Integrated Diagnostic System (IDS) to the latest calibration using IDS release 105.04 or higher.
Failure to maintain both modules at the same software level causes the traction control (TC) switch on the instrument panel to become inoperative.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
Calibration files may also be obtained at www.motorcraftservice.com.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford
, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
