| “This site contains affiliate links for which OEMDTC may be compensated” |
SSM 46481 – 2016 – 2017 Edge/MKX – With Lane Keeping System And Adaptive Steering – Inoperative Lane Keeping System – Built On Or Before 01-Feb-2017
Some 2016 and 2017 Edge/MKX vehicles equipped with lane keeping system, adaptive steering, and built on or before 01-Feb-2017 may exhibit an inoperative lane keeping system.
If the vehicle exhibits this concern, reprogram the SECM to the latest software level using Integrated Diagnostic System (IDS) release 104.04 or higher.
Make sure you are connected to the internet when downloading as-built data.
For claiming, use causal part 3504 and applicable labor operations in Section 3 or 10 of the Service Labor Time Standards (SLTS) Manual.
APPLICABLE VEHICLES
2016 – 2017 CAR: DQ CD539N-EDGE
2016 – 2017 CAR: D9 U540 – LINCOLN
MKX
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
My parents had a head on collision for no reason. The car was a week old, just wondering if there has been more troubles with them?