| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 12-1-7 |
|
| Publication Date: January 16, 2012 | |
FORD : | 2012 Focus |
ISSUE:
Some 2012 Focus vehicles built on or before 8/16/2011 and equipped with 2 inch (5 cm) instrument cluster (IC) message center display showing dark horizontal lines in the message center and/or accompanied by an intermittent sticking or erratic fuel gauge. The concern may be intermittent and may clear after a few minutes. The distance-to-empty (DTE) reading is not affected by this concern.
Reprogram the IC module to the latest calibration using IDS release 76.03 and higher. This new calibration is not included in the VCM 2011.11 DVD. Calibration and IDS patch files may also be obtained at www.motorcraft.com.
WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
| OPERATION | DESCRIPTION | TIME |
| 120107A | 2012 Focus: Reprogram The IC (Do Not Use With Any Other Labor Operations) | 0.3 Hr. |
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 10849 | 04 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
