| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 13-6-6 |
|
| Publication Date: June 5, 2013 | |
FORD : | 2013 Focus |
ISSUE:
Some 2013 Focus vehicles equipped with IKT keys and built on 11/21/2012 and through 3/30/2013 may exhibit the dome light not illuminating when unlocking the vehicle with the IKT fob unlock button after the vehicle has been left engine off and undisturbed for 30 minutes or more.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Verify the dome light does not illuminate when unlocking the vehicle with the IKT fob unlock button after the vehicle has been left with engine off and undisturbed for 30 minutes or more.
- Press the lock button on the IKT fob and then press the unlock button on the IKT fob again. Did the dome light turn on?
- Yes – proceed to Step 3.
- No – this article does not apply. Refer to Workshop Manual, Section 417-02 for normal diagnostics.
- Reprogram the body control module (BCM) to the latest calibration using IDS release 84.01 and higher. Calibration files may also be obtained at www.motorcraft.com.
WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
| OPERATION | DESCRIPTION | TIME |
| 130606A | 2013 Focus: Identify Customer Concern And Reprogram The BCM (Do Not Use With Any Other Labor Operations) | 0.3 Hr. |
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| 14A068 | 42 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
