| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 13-4-22 |
|
| Publication Date: April 29, 2013 | |
| FORD: | 2013 C-MAX |
ISSUE:
Some 2013 C-MAX Hybrid/Energi vehicles built on or before 4/9/2013 may exhibit illuminated wrench lamp or red triangle lamp or both with diagnostic trouble code (DTC) P061A in the powertrain control module (PCM) and/or U1011 in the transmission control module (TCM) and/or P060C in the TCM.
ACTION:
Reprogram the PCM to the latest calibration using IDS release 84.02 and higher. Calibration files may also be obtained at www.motorcraft.com.
WARRANTY STATUS:
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
| OPERATION | DESCRIPTION | TIME |
| 130422A | 2013 C-MAX: Check DTCs and Reprogram The PCM.(Do Not Use With Any Other Labor Operation) | 0.4 Hr. |
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| RECALEM | 04 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
