| “This site contains affiliate links for which OEMDTC may be compensated” |
| 1.5L GTDI – MALFUNCTION INDICATOR LAMP (MIL) ILLUMINATED WITH DTCS P0036, P0137, P0138 AND/OR P0141 – BUILT ON OR BEFORE 8/22/2015 |
FORD : | 2016 Fusion |
ISSUE:
Some 2016 Fusion vehicles equipped with a 1.5L gasoline turbocharged direct injected (GTDI) engine and built on or before 8/22/2015 may exhibit an illuminated MIL with one or more of the following diagnostic trouble codes (DTCs): P0036, P0137, P0138 and/or P0141.
ACTION:
Follow the Service Procedure steps to correct the condition.
SERVICE PROCEDURE
- Using an Integrated Diagnostic System (IDS) or equivalent scan tool check for DTCs. Is DTC P0036, P0137, P0138 and/or P0141 present in powertrain control module (PCM) memory?
- Yes – proceed to Step 2.
- No – this article does not apply. Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual for normal diagnostics.
- Reprogram the PCM to the latest calibration using IDS or Ford J2534 release 97.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.
- Replace the bank 1, sensor 2 catalyst monitor sensor (CMS). Refer to Workshop Manual (WSM), Section 303-14.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
