| “This site contains affiliate links for which OEMDTC may be compensated” |
2015 Edge – Power Liftgate Inoperable From Instrument Panel (IP) Switch, Exterior Liftgate Switch And Key Fob – Built On Or Before 4/17/2015
2015 Edge vehicles built on or before 4/17/2015 can exhibit a power liftgate that will not operate from the IP switch, exterior liftgate switch, and key fob.
Power lifgate may also be stuck in the secondary latch position with the liftgate ajar light illuminated.
To correct the concern update the Rear Gate Trunk Module (RGTM) to the latest calibration using IDS or Ford J2534 version 96.01 or higher.
Make sure you are connected to the internet when entering module programming to obtain the latest updates.
After updating the RGTM, open the liftgate using the exterior liftgate switch, IP switch, or key fob and perform the power liftgate initialization procedure.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
