Single CD Radio may Exhibit Poor Sound Quality – 2014 Ford Transit Connect

RADIO WITH SINGLE CD, POOR SOUND QUALITY – BUILT ON OR BEFORE 12/1/2013

 

FORD:

2014 Transit Connect

 

2014 Transit Connect vehicles built on or before 12/1/2013 and equipped with single CD radio may exhibit poor sound quality, in which the audio system is not optimized for the cabin style and size.

 

SERVICE PROCEDURE

1. Using the Ford Integrated Diagnostic System (IDS) or Ford J2534, start a new session.
2. ID the vehicle.
3. Check the Audio Control Module (ACM) part number, using the IDS Log Viewer. Is the part number DT1T-19C107-A* or DT1T-19C107-C*?
   1. Yes – proceed to step 4.
   2. No – this article does not apply. Refer to WSM, Section 415-00 for normal diagnosis.
4. Select the tool box at the vehicle screen.
   1. Select Module Programming.
   2. Select As-Built.
   3. Select ACM.
5. Follow the on-screen prompts until As-Built is complete.

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com