Illuminated Wrench Lamp (Hybrid) or Service Engine Soon lamp (Energi) DTC P1A18 P1A19 P0AEE P0BCD – 2013-2014 Ford Fusion & Lincoln MKZ

TSB 14-0106

WRENCH OR SERVICE ENGINE SOON LAMP ILLUMINATED AND CONTINUOUS MEMORY DIAGNOSTIC TROUBLE CODE (CMDTC) P1A18, P1A19, P0AEE OR P0BCD

 

FORD:	2013-2014 Fusion
LINCOLN:	2013-2014 MKZ

 

This article supersedes TSB 14-0089 to update the vehicle model lines.

 

ISSUE:

Some 2013-2014 Fusion and MKZ Hybrid/Energi vehicles may exhibit an illuminated Wrench lamp (Hybrid) or Service Engine Soon lamp (Energi) accompanied by CMDTC P1A18, P1A19, P0AEE or P0BCD.

 

ACTION:

Reprogram the powertrain control module (PCM) to the latest calibration using IDS or Ford J2534 release 90.01 and higher.

Calibration files may also be obtained at www.motorcraft.com.

OPERATION	DESCRIPTION	TIME
140106A	2013-2014 Fusion And MKZ Hybrid/Energi: Reprogram The Appropriate Modules As Required By The Software Update Includes Time To Clear Codes After Repair (Do Not Use With Any Other Labor Operations)	0.5 Hr.

 

WARRANTY STATUS

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

 

DEALER CODING

BASIC PART NO.	CONDITION CODE
RECALEM	04

 

 

 

---

 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

• Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
• Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com