Illuminated MIL And Wrench Lamp Indicator With Only DTC P074C

“This site contains affiliate links for which OEMDTC may be compensated”

DPS6 – ILLUMINATED MALFUNCTION INDICATOR LAMP (MIL) AND WRENCH LAMP INDICATOR – DIAGNOSTIC TROUBLE CODE (DTC) P074C – BUILT ON OR BEFORE 2/4/2015

FORD:

2015 Focus

2015 Focus vehicles equipped with a DPS6 transmission and built on or before 2/4/2015 may exhibit an illuminated MIL and Wrench Lamp indicator with only DTC P074C present or stored in the powertrain control module (PCM).

SERVICE PROCEDURE

Reprogram the PCM to the latest calibration level using IDS or Ford J2534 release 95.01 or higher. Make sure you are connected to the internet when entering module programming to obtain the latest updates. Calibration files may also be obtained at www.motorcraftservice.com.

Using IDS or equivalent Scan Tool, select Powertrain, Transmission, Transmission Adaptive Learning and perform the Clutch Adaptive Learn.

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device using Ford Module Programming (FMP) can Reprogram and Configure most Modules.