Factory Remote Start – Activated Heated Seat Operation – 2013 Ford Taurus

“This site contains affiliate links for which OEMDTC may be compensated”

2013 Taurus – Factory Remote Start – Activated Heated Seat Operation

2013 Taurus vehicles equipped with factory remote start, dual automatic temperature control (DATC), and heated seats may experience heated seat operation after a remote start without customer input, on non-intelligence access (IA) equipped vehicles.

 

This applies to vehicles equipped with heated only seats, and does not apply to vehicles equipped with heated and cooled seats.

 

Reprogram the HVAC to the latest calibration using release 94.03 or higher.

 

Make sure you are connected to the internet when entering module programming to obtain the latest updates.

 

Calibration files may also be obtained at www.motorcraftservice.com

 


 

Service Information & Reprogramming

Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.

Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:

  • Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
  • Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)

In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.

J2534 Device Factory Remote Start - Activated Heated Seat Operation - 2013 Ford Taurus | small light Factory Remote Start - Activated Heated Seat Operation - 2013 Ford Taurus | small light Factory Remote Start - Activated Heated Seat Operation - 2013 Ford Taurus | small light Factory Remote Start - Activated Heated Seat Operation - 2013 Ford Taurus | small light using Ford Module Programming (FMP) can Reprogram and Configure most Modules.

Latest Calibration Information

Module Build Data (As-Built)
Use VIN to obtain As-Built data

www.motorcraftservice.com

 

Leave a Comment

Share to...