| “This site contains affiliate links for which OEMDTC may be compensated” |
| TSB 13-12-17 | ENERGI – SERVICE ENGINE SOON LAMP AND DTC P2183 |
| Publication Date: December 6, 2013 | |
FORD : | 2013 C-MAX 2014 Fusion |
ISSUE:
Some 2013 C-MAX Energi vehicles, and 2014 Fusion Energi vehicles built on or before 11/5/2013 may illuminate the Service Engine Soon lamp accompanied by diagnostic trouble code (DTC) P2183 in the powertrain control module (PCM).
ACTION:
Reprogram the PCM to the latest calibration using IDS release 87.05 and higher. Calibration files may also be obtained at www.motorcraft.com.
At the Module Reprogramming screen in the IDS service tool, select Program PCM. By selecting PCM the update will be applied to the appropriate modules as required by the software update.
| OPERATION | DESCRIPTION | TIME |
| 131217A | 2013 C-MAX And 2014 Fusion Energi: Reprogram The Appropriate Modules As Required By The Software Update Includes Time To Clear Codes After Repair (Do Not Use With Any Other Labor Operations) | 0.5 Hr. |
WARRANTY STATUS
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage.
Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.
DEALER CODING
| BASIC PART NO. | CONDITION CODE |
| RECALEM | 04 |
Loading...
Reload document 
Open in new tab
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
