| “This site contains affiliate links for which OEMDTC may be compensated” |
2013-2015 Fusion/MKZ – Unable To Complete PSCM Module Programming After PSCM Replacement Resulting In DTC U2100
2013-2015 Fusion/MKZ vehicles may have a Power Steering Control Module (PSCM) that is unable to complete programmable module installation (PMI) following PSCM replacement due to the IDS not recognizing the replacement part as being valid, resulting in DTC U2100.
To allow the Programmable Module Installation process to complete, make sure the IDS is at version 97.03 or higher.
Make sure you are connected to the internet to obtain the latest IDS software updates.
Service Information & Reprogramming
Software necessary to program electronic modules to the latest calibration level, perform module initialization (PATS), and set Programmable Parameters on Ford, Lincoln and Mercury vehicles.
Ford Module Programming (FMP) is a software application that allows subscribers to program electronic modules on Ford, Lincoln and Mercury vehicles. It can be used for:
- Reprogramming emission-related (OBDII) modules on some vehicles manufactured in 1995 and all vehicles manufactured from 1996 to the present
- Reprogramming or reconfiguring non-emission-related modules on many vehicles (UBP and MS-CAN not supported)
In addition, module initialization (PATS) functions such as Keycode Erase/Reprogram and PCM Parameter Reset can be done using this application.
J2534 Device 
using Ford Module Programming (FMP) can Reprogram and Configure most Modules.
Latest Calibration Information
Module Build Data (As-Built)
Use VIN to obtain As-Built data
